Configuration Examples - Dell PowerConnect B-FCXs Configuration Manual

PowerConnect#show span pvst-mode
PVST+ Enabled on:
Port
1/1
1/2
2/10
3/12
4/24
Syntax: show span pvst-mode
This command displays the following information.
TABLE 55
This field...
Port
Method

Configuration examples

The following examples show configuration examples for two common configurations:
•
•
Tagged port using default VLAN 1 as its port native VLAN
Figure 54
VLAN and VLANs 2, 3, and 4 as tagged VLANs.
FIGURE 54
To implement this configuration, enter the following commands.
PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Method
Set by configuration
Set by configuration
Set by auto-detect
Set by configuration
Set by auto-detect
CLI display of PVST+ information
Untagged IEEE 802.1Q BPDUs on VLAN 1 and tagged PVST+ BPDUs on other VLANs
Tagged IEEE 802.1Q BPDUs on VLAN 1 and untagged BPDUs on another VLAN
shows an example of a PVST+ configuration that uses VLAN 1 as the untagged default
Default VLAN 1 for untagged BPDU
Displays...
Dell PowerConnect
The
NOTE: The command lists information only for the ports on which
PVST+ support is enabled.
The method by which PVST+ support was enabled on the port. The
method can be one of the following:
•
Set by configuration – You enabled the support.
•
Set by auto-detect – The support was enabled automatically when
the port received a PVST+ BPDU.
Untagged IEEE BPDU for VLAN 1
Untagged PVST BPDU for VLAN 1
Tagged PVST BPDUs for VLANs 2, 3, 4
Port1/1
PVST/PVST+ compatibility
port number.
Another
device
Port1/2
8
279