Bracket Mounting - Visonic CLIP PG2 Installation Instructions Manual

2.3 Bracket Mounting

Note: When mounting using the bracket, the back tamper
becomes inoperative.
1. Drill two 7 mm (1/4") holes at the marked locations
Figure 10. Drilling Holes
*
1
*
95
O
*
5
O
D-303370 CLIP PG2 Installation Instructions
1
A
**
2
**
B
100
O
**
10
B
O
1. Drill two holes in the mounting surface.
2. Secure the bracket with two screws.
A. Mounting surface
B. Top view
Note:
The bracket provides two mounting options
For optimum angle coverage:
use these two holes to shift the coverage angle by 5° away
∗
from the wall
∗∗ use these two holes to shift the coverage angle by 10° away
from the wall
Figure 11. Mounting Bracket to Surface
2
A
3
1. Place the base slots over the two bracket pins.
2. Place the locking plate over the two pins.
3. Secure the locking plate by pressing downward.
A. Locking plate
Figure 12. Securing Locking Plate to Base
1
2
1. Position the PCB correctly in the base.
2. Insert the screw to secure the cover with the base.
Figure 13. Mounting Cover to Base
1
3