Show Sharing Address-Based - Extreme Networks ExtremeWare Command Reference Manual

Commands for Configuring Slots and Ports on a Switch

show sharing address-based

show sharing address-based
Description
Displays the address-based load sharing configuration.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
This feature is available using the address-based load-sharing algorithm only. The address-based
load-sharing algorithm uses addressing information to determine which physical port in the
load-sharing group to use for forwarding traffic out of the switch. Addressing information is based on
the packet protocol, as follows:
• IP packets—Uses the source and destination MAC and IP address, and the TCP port number.
• IPX packets—Uses the source and destination MAC address and IPX identifiers.
• All other packets—Uses the source and destination MAC address.
To verify your configuration, use the command. The show sharing
show sharing address-based
address-based output displays the addressed-based configurations on the switch.
Example
The following example displays the address-based load sharing configuration on the switch:
show sharing address-based
Following is the output from this command:
Sharing address-based = L2_L3_L4
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on the "i" series platform and the Alpine 3800 series switch modules.
218 ExtremeWare Software 7.0.0 Command Reference Guide