Config Gvrp - Extreme Networks ExtremeWare Command Reference Manual

config gvrp

config gvrp {listen | send | both | none} port <portlist>
Description
Configures the sending and receiving of Generic VLAN Registration Protocol (GVRP) information on a
port.
Syntax Description
listen
send
both
none
portlist
Default
Both sending and receiving.
Usage Guidelines
GVRP must be enabled on the switch as a whole before GVRP data can be sent or received on
individual ports.
If GVRP is enabled,
sent on the specified ports, to neighboring GVRP-enabled switches.
If GVRP is enabled,
on the specified ports, from neighboring GVRP-enabled switches.
Example
The following commands configure port 3 to receive GVRP information only (by default it can send and
listen) and then enables GVRP:
config gvrp listen port 3
enable gvrp
If the switch receives GVRP information on this port, it will do one of the following:
• If a tagged VLAN already exists with a VLANid that matches the VLANid in the GVRP data, and
port 3 is not already a member of that VLAN, add it as a tagged port.
• If no VLAN exists with a VLANid that matches the VLANid in the GVRP data, create a VLAN with
the VLANid specified in the GVRP data, and add port 3 as a tagged member port.
History
This command was first available in ExtremeWare 2.0.
This command exists but is not supported in ExtremeWare version 6.1 and later.
ExtremeWare Software 7.0.0 Command Reference Guide
Enables the receipt of GVRP packets on the specified port(s).
Enables sending of GVRP packets on the specified port(s).
Enables both sending and receiving of GVRP packets.
Disables the port from participating in GVRP operation.
Specifies one or more ports. May be in the form 1, 2, 3-5, 2:5, 2:6-2:8.
causes information (GVRP packets) about tagged VLANS on the switch to be
send
means that the switch will receive and act on GVRP information it receives
listen
config gvrp
229