Config Ports Auto On - Extreme Networks ExtremeWare Command Reference Manual

config ports auto on

config ports [<portlist> | mgmt | all] auto on
Description
Enables autonegotiation for the particular port type.
Syntax Description
portlist
mgmt
all
Default
Auto on.
Usage Guidelines
On a modular switch,
can be one or more port numbers. For a detailed explanation of port specification, see "Modular Switch
Numerical Ranges" or "Stand-alone Switch Numerical Ranges" in Chapter 1.
The type of ports enabled for autonegotiation are 802.3u for 10/100 Mbps ports or 802.3z for Gigabit
Ethernet ports.
Flow control is supported on Gigabit Ethernet ports only. It is enabled or disabled as part of
autonegotiation. If autonegotiation is set to off, flow control is disabled. When autonegotiation is turned
on, flow control is enabled.
For version 6.1:
• The parameter specifies all ports on the switch.
all
Example
The following command configures the switch to autonegotiate for ports 4 and 6 on a stand-alone
switch:
config ports 4,6 auto on
The following command configures the switch to autonegotiate for slot 1, ports 2 and 4 on a modular
switch:
config ports 1:2, 1:4 auto on
ExtremeWare Software 7.0.0 Command Reference Guide
Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 3-5, 2:5, 2:6-2:8.
Specifies the management port. Supported only for switches that provide a
management port.
Specifies all configured ports on the switch. (6.1 and higher) See "Usage
Guidelines" for more information.
can be a list of slots and ports. On a stand-alone switch,
<portlist>
config ports auto on
<portlist>
165