Enable Snmp Traps Mac-Security - Extreme Networks ExtremeWare Command Reference Manual

enable snmp traps mac-security

enable snmp traps mac-security
enable snmp traps mac-security
Description
Enables SNMP mac-security traps for all ports to be sent by the switch.
Syntax Description
This command has no arguments or variables.
Default
Disabled.
Usage Guidelines
This command should be used in conjunction with the config ports <portlist> limit-learning command.
That command configures a limit on the number of MAC addresses that can be learned on a port(s).
After that limit has been reached on a particular port, a trap will be sent by the switch, if a new MAC
address appears on that port. In addition, a message will be generated in the syslog and the port will be
blackholed.
Example
The following command allows SNMP mac-security traps to be sent from the switch.
enable snmp traps mac-security
History
This command was first available in ExtremeWare 7.0.0.
Platform Availability
This command is available on all platforms.
ExtremeWare Software 7.0.0 Command Reference Guide 127