Config Ports - Extreme Networks ExtremeWare Command Reference Manual

Commands for Configuring Slots and Ports on a Switch

config ports

config ports [<portlist> vlan <vlan name> | all] [limit-learning <number> |
lock-learning | unlimited-learning | unlock-learning]
Description
Configures virtual ports for limited or locked MAC address learning.
Syntax Description
portlist
all
vlan name
limit-learning <number>
lock-learning
unlimited-learning
unlock-learning
Default
Unlimited, unlocked learning.
Usage Guidelines
On a modular switch,
<portlist>
can be one or more port numbers. For a detailed explanation of port specification, see "Modular Switch
Numerical Ranges" or "Stand-alone Switch Numerical Ranges" in Chapter 1.
Limited learning. The limited learning feature allows you to limit the number of dynamically-learned
MAC addresses per VLAN. When the learned limit is reached, all new source MAC addresses are
blackholed at both the ingress and egress points. This prevent these MAC addresses from learning and
responding to Internet control message protocol (ICMP) and address resolution protocol (ARP) packets.
If the limit you configure is greater than the current number of learned entries, all the current learned
entries are purged.
Dynamically learned entries still get aged, and can be cleared. If entries are cleared or aged out after the
learning limit has been reached, new entries will then be able to be learned until the limit is reached
again.
Permanent static and permanent dynamic entries can still be added and deleted using the
and
fdbentry delete fdbentry
For ports that have a learning limit in place, the following traffic will still flow to the port:
• Packets destined for permanent MACs and other non-blackholed MACs
160
Specifies one or more ports or slots and ports. On a modular switch, can be a
list of slots and ports. On a stand-alone switch, can be one or more port
numbers. May be in the form 1, 2, 3-5, 2:5, 2:6-2:8.
Specifies that all virtual ports should be configured as indicated.
Specifies the name of the VLAN.
Specifies a limit on the number of MAC addresses that can be dynamically
learned on the specified ports.
Specifies that the current FDB entries for the specified ports should be made
permanent static, and no additional learning should be allowed.
Specifies that there should not be a limit on MAC addresses that can be
learned.
Specifies that the port should be unlocked (allow unlimited, dynamic learning).
can be a list of slots and ports. On a stand-alone switch,
commands. These override any dynamically learned entries.
<portlist>
create
ExtremeWare Software 7.0.0 Command Reference Guide