Extreme Networks ExtremeWare Command Reference Manual page 85

Example
The following command displays current switch information:
show switch
Output from this command looks similar to the following:
SysName:
SysLocation:
SysContact:
System MAC:
License:
System Mode:
RED Probability:
DLCS:
SysHealth Check:
Recovery Mode:
System Watchdog:
Current Time:
Timezone:
Boot Time:
Next Reboot:
Timed Upload:
Timed Download:
Temperature:
Power supply:
Image Selected:
Image Booted:
Primary EW Ver:
Secondary EW Ver: 6.2.2b19
Config Selected:
Config Booted:
Primary Config:
Secondary Config: Created by EW Version: 6.2.2 Build 27 [37]
History
This command was first available in ExtremeWare 2.0.
This command was modified in ExtremeWare 7.0.0.
ExtremeWare Software 7.0.0 Command Reference Guide
Alpine3808
Extreme Networks HQ
Carlos_Beronio
00:01:30:20:0A:00
Full L3 + Security
802.1Q EtherType is 8100 (Hex).
0
Enabled
Enabled. Alarm Level = Log
All - System-dump/Reboot
Enabled
Mon Nov 4 08:29:23 2002
[Auto DST Enabled] GMT Offset: 0 minutes, name is GMT.
DST of 60 minutes is currently not in effect, name is not set.
DST begins every first Sunday April at 2:00
DST ends every last Sunday October at 2:00
Wed Oct 23 10:13:07 2002
None scheduled
None scheduled
None scheduled
Normal. All fans are operational.
Upper (PSU-A) not present,
Primary
Primary
6.2.2b27
Primary
Primary
Created by EW Version: 6.2.2 Build 27 [37]
6416 bytes saved on Thu Oct 31 08:56:03 2002
6368 bytes saved on Thu Oct 24 15:27:41 2002
CPU Tx-Priority = High
Lower (PSU-B) OK
show switch
85