Enable License - Extreme Networks ExtremeWare Command Reference Manual

Commands for Accessing the Switch

enable license

enable license [basic_L3 | advanced_L3 | full_L3 ] <license_key>
Description
Enables a particular software feature license.
Syntax Description
basic_L3
advanced_L3
full_L3
license_key
Default
N/A
Usage Guidelines
Specify as an integer.
license_key
The
unconfig switch all
disabled after the license has been enabled on the switch.
Depending on the software version running on your switch, and the type of switch you have, only the
license parameters applicable to your software or switch can be used.
To view the type of license you are currently running on the switch, use the
The license key number is not displayed, but the type of license is displayed in the
output. The type of license is displayed after the system name, system location, system contact, and
system MAC address.
Example
The following command enables a full L3 license on the switch:
enable license fullL3
History
This command was first available in ExtremeWare 4.0.
Platform Availability
This command is available on all platforms.
76
Specifies a basic L3 license. (4.x only)
Specifies an advanced L3 license. (4.x only)
Specifies a full L3 license. (6.0, 6.1 and higher)
Specifies your software license key.
command does not clear licensing information. This feature cannot be
command.
show switch
show switch
ExtremeWare Software 7.0.0 Command Reference Guide