Config Snmp Access-Profile Readwrite - Extreme Networks ExtremeWare Command Reference Manual

config snmp access-profile readwrite

config snmp access-profile readwrite [<access-profile> | none]
Description
Assigns an access profile that limits which stations have read/write access to the switch.
Syntax Description
access-profile
none
Default
All users have access until an access profile is specified.
Usage Guidelines
The ability to read SNMP information can be restricted through the use of an access profile. An access
profile permits or denies a named list of IP addresses and subnet masks.
You must create and configure an access profile before you can use this command. You create an access
profile using the
access-profile
Use the
none
Read/write community strings provide read and write access to the switch. The default read/write
community string is private. Sixteen read-only and sixteen read-write community strings can be
configured on the switch, including the defaults. The community string for all authorized trap receivers
must be configured on the switch for the trap receiver to receive switch-generated traps. SNMP
community strings can contain up to 127 characters.
To view the SNMP read/write access communities configured on the switch, use the
command. The
and the number of read/write communities configured on the switch.
To restore defaults to all SNMP-related entries, including the SNMP parameters modified using the
config snmp access-profile readwrite
Example
The following command allows the user defined access profile management read/write access to the
switch:
config snmp access-profile readwrite management
History
This command was first available in ExtremeWare 6.0.
ExtremeWare Software 7.0.0 Command Reference Guide
Specifies a user defined access profile.
Cancels a previously configured access profile.
create access-profile
command.
option to remove a previously configured access profile.
command displays information about the switch including the names
show management
command. You configure an access profile using the
command, use the
unconfig management
config snmp access-profile readwrite
config
show management
command.
93