Modifying Policies - Extreme Networks EPICenter Reference Manual

b Click the entry in the QoS Profile column for the selected resource, or in the QoS Profile field
below the list. In either case, a drop-down list of the available QoS profiles is displayed, from
which you can select the profile you want to associate with this policy.
c To enter a comment about this resource, enter it in the Comment field below the resource list.
NOTE
For devices running older versions of ExtremeWare (prior to 6.x) only four QoS profiles (QP1-QP4) are supported.
If you select a profile that is not supported on the device you are configuring, your selection will be ignored.
3 When you have finished adding resources to the Current Policy Access Domain Resources list, click
the OK button at the bottom of the window. This closes the Edit window and displays the contents
of the Current Policy Scope Resources list in the appropriate resource list in the Policy Traffic area.
Click Cancel to close the Edit window and abandon any changes you have made to the Current
Policy Scope Resources list.

Modifying Policies

To modify a network policy, you follow the same steps you use to create a policy, but you start with the
settings of the current policy. You can change any of the policy settings, including the policy name and
policy type.
To modify a policy, follow these steps:
1 Click the Policies radio button just above the component tree to display a summary of the policies
currently known to the Policy Manager.
2 Select the policy you want to modify either in the component tree or from the list of policies. This
displays the Policy Description page for the selected policy, as shown in
EPICenter Reference Guide
Modifying Policies
Figure 262.
499