Extreme Networks EPICenter Reference Manual page 427

Figure 218: Rogue Access Point Detection Report
For each Rogue Access Point detected, the following information is provided:
Rogue AP MAC
Manufacturer
Mode
Channel
SSID
Possible Connected Devices
Nearest Detecting AP
Nearest Detecting Location
First Detected
You can view the details for each of the detected rogue APs through the Rogue Access Point Detail
Report.
Rogue Access Point Detail Report
This report shows you information about an AP that has been detected as a rogue, as well as
information about how and where it was detected.
EPICenter Reference Guide
MAC address of the AP. Click the link in this cell to view the Rogue Access Point
Detail Report for this AP.
Manufacturer of the AP
Wireless LAN RF mode: 802.11a, 802.11b, or 802.11g/b
Radio frequency channel used by the rogue interface
Service set ID for the wireless interface
The switch(es) the EPICenter MAC Poller has determined could be where the
rogue AP is connected. There can be multiple devices in this field, if EPICenter
detected the MAC address on more than one switch.
Click the link in this cell to view a Device Details report for this device.
If multiple APs detected the rogue, the identity of the nearest detecting AP.
Click the link in this cell to view a Wireless Port Details report for this AP.
The location of the nearest detecting AP
The time at which this rogue AP was first detected
Wireless Reports
427