Link Status; Reorganizing The Map View - Extreme Networks EPICenter Reference Manual

Figure 234: Map node display at outermost zoom level

Link Status

Links between devices may be single links (a connection exists between only one port on each device)
or bundled links (connections exist between multiple ports on each of the devices.)
Single links are shown as a single line. Bundled links are shown with a small box within the link.
A green line indicates that the link is up.
●
A red line indicates that the link is down
●
A yellow line indicates that the link status is unknown. For a bundled link, yellow may indicate
●
that some links are down (or unknown) and some are up.
When the map is zoomed in sufficiently, the port endpoints are automatically displayed for each link.
When the map is zoomed out, the port endpoints are not shown automatically; move the cursor over a
link to display the ports that are the endpoints of that link.

Reorganizing the Map View

There are a number of ways to manipulate the view of your network as shown on the EAPS map.
You can reorganize the placement on the nodes in the map either by asking EPICenter to calculate a
●
layout, or by dragging nodes around yourself. (You must have write access to the EAPS Monitor in
order to perform this function—Read-Only users cannot do this.)
You can zoom in and out either by command or by using the Zoom slider on the right-hand side of
●
the viewport, or you can zoom in on selected domains or devices using by selecting them in the
Domain or device table.
Depending on the zoom level, individual nodes may be displayed with only minimal information.
At the outermost zoom levels, nodes may be represented only by their status icons, with their IP
addresses and system names hidden (see
EPICenter Reference Guide
EAPS Master Node
Device Up with Alarm
Move cursor over node to
display node information (name,
IP address, domains)
Display the EAPS Log report for
this device
Enter Focus Mode for this Domain
Figure 234 on page 459).
Link Status
459