Extreme Networks EPICenter Reference Manual page 62

The Inventory Manager
1 Click the Discover button at the top of the Inventory Manager main window to display the Discover
Devices window, as shown in
Figure 19: Inventory Manager Discover Devices set up window
2 Enter your settings (Vendor Filters selection, IP address range, subnet mask, etc.) in the top portion
of the window.
The fields and buttons in this window are defined as follows:
Extreme only
All MIB-2 devices
IP Address with Wild Cards
IP Address Range
IP Address/Net Mask(CIDR)
62
Figure 19.
Select this button to discover Extreme devices only.
Select this button to discover all MIB-2 compatible devices.
Specify the device address range using wild cards, such as 10.203.10.* or
10.203.?.??
Valid wildcard characters are *, ?, and - (dash):
*
acts as a wildcard for the entire octet (0-255).
? is a wildcard for a single digit (0-9).
- lets you specify a range for any octet. You can use this in more than one
octet. Note that you cannot combine the dash with another wildcard in the
same octet.
You can also use the IP Address with Wild Cards field to specify a single IP
address.
Specify the device address range, such as 10.203.10.20 to 10.203.10.45.
Specify the device address range, in Classless InterDomain Routing (CIDR)
format. The value in the Subnet Mask field is the number of bits to be masked,
starting from the high-order (left-hand) octet.
EPICenter Reference Guide