Table of Contents
Advertisement
Configuring the Wireless AP
8 Click Add Altitude AP. The Wireless AP is added and registered.
When a Wireless AP is added manually, it is added to the controller database only and does not get
assigned.
9 Click Close.
Modifying Wireless AP Settings
Wireless APs are added with default settings, which you can adjust and configure according to your
network requirements. In addition, you can modify the properties and the settings for each radio on the
Wireless AP.
You can also locate and select Wireless APs in specific registration states to modify their settings. For
example, this feature is useful when approving pending Wireless APs when there are a large number of
other Wireless APs that are already registered. From the Access Approval screen, click Pending to
select all pending Wireless APs, then click Approve to approve all selected Wireless APs.
Modifying a Wireless AP's Status
If during the discovery process, the Summit WM Controller security mode was Allow only approved
Altitude APs to connect, then the status of the Wireless AP is Pending. You must modify the security
mode to Allow all Altitude APs to connect. For more information, see
To modify a Wireless AP's registration status:
1 From the main menu, click Altitude APs. The Altitude APs screen is displayed.
64
"Security Mode" on page
Summit WM20 User Guide, Software Release 4.2
60.
Advertisement
Table of Contents
