Extreme Networks EPICenter Reference Manual page 554

Voice over IP Manager
Figure 281: Select Voice over IP window
In this window you can select individual VLANs, and enable or disable VoIP for that VLAN.
The Select Voice over IP VLANs table shows information about each switch in the selected VLAN:
Enabled
IP Address
Switch
QoS Profile
Priority
Min Bw
Max Bw
The VoIP Manager applet assumes that you have already set up the VLANs you will be using for
your VoIP traffic.
3 To display a VLAN, pull down the list of VLANs from the All VLANs field at the top of the
window, and select a VLAN, as shown in
554
A green check indicates that this switch is selected as part of the VoIP VLAN. A red X
indicates that this device has not been selected (or has been deselected). As a rule,
all devices in the VLAN will be enabled or disabled for VoIP, and switches cannot be
enabled or disabled individual. However, if a device is added to the VLAN after the
VLAN has been enabled, that switch will not be enabled until you re-enable the entire
VLAN.
The IP address assigned to the VLAN on the switch. This may be blank if the VLAN
does not have an IP address assigned (as is the case with the Default VLAN).
The name of the switch.
The QoS profile assigned to this VLAN on this switch.
The priority associated with the QoS profile.
The minimum bandwidth for this QoS profile.
The maximum bandwidth for this QoS profile.
Figure 282.
EPICenter Reference Guide