HP XP P9500 Manual page 77

Table 13 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKM7x) (continued)
Message ID Message Text
YKM759E ISPF Enter numeric characters (0-9).
YKM760E ISPF Preset Mode cannot be used
when C/T ID is not specified.
YKM761E ISPF Check Device Num, Volser, or
Non Gen'ed.
YKM762E ISPF You cannot perform a NG
scan because the specified
DADID matches a local or
remote DADID.
YKM763E ISPF You cannot perform a NG
scan because no local scan
has been performed for the
specified storage system.
YKM764E ISPF Select one of the displayed
lines.
YKM765I ISPF A description for the specified
error code was not found.
YKM766E ISPF Specified Prefix is being used
by another program.
YKM767E ISPF This command is invalid for CA
Copy Groups linkaged with
HyperSwap.
YKM768E ISPF HS cannot be used when C/T
ID is specified.
YKM769E ISPF Route Label must be an asterisk
(*), or a combination of one
or more qualifiers. Each
qualifier must be 1-8
alphanumeric characters (0-9,
A-Z, a-z) with the first character
being an alphabetic character
(AZ, a-z). The length of Route
Label must be 1-8.
YKM770E ISPF Enter unique value in a storage
system.
YKM771I ISPF Panel could not scroll because
it shows beginning of data.
YKM772I ISPF Panel could not scroll because
it shows end of data.
YKM773E ISPF DADID must be shortened so
that dataset name of disk
configuration file is no more
than 44 characters.
YKM774E ISPF Specified storage system is
defined in the same route.
Explanation and Recommended Actions
Enter a numeric value (0-9).
You cannot set the Preset Mode without specifying a C/T group
ID.
Check the value specified in Device Num, Volser, or Non
Gen'ed.
You cannot perform a NG scan, because the specified device
address domain ID is the same as the local device address
domain ID or remote device address domain ID. For details
about the NG scan, see the HP P9000 for Business Continuity
Manager Software Reference Guide.
You cannot perform a NG scan, because a local scan has not
been performed for the specified storage system. For details
about the NG scan, see the HP P9000 for Business Continuity
Manager Software Reference Guide.
Select one of the displayed lines.
A description for the specified error code was not found.
For details about error codes, see
Information" (page 165). If the error code is not listed in the
manual, contact maintenance personnel.
The specified prefix is being used by another program.
Check the value specified for the prefix.
The command cannot be executed for BC Z copy groups with
the HyperSwap attribute.
Execute the PPRC copy pair operation from TPC-R.
If a consistency group ID is specified, you cannot specify HS
for the linkage option.
The route label must be an asterisk (*), or a combination of one
or more qualifiers. Each qualifier must be from 1 to 8
alphanumeric characters (0-9, AZ, a-z), and must begin with
an alphabetic character (A-Z, a-z). The length of the route label
must be from 1 to 8 characters.
Enter a value that is unique within the storage system.
The panel cannot be scrolled because the start of the data is
already being displayed.
The panel cannot be scrolled because the end of the data is
already being displayed.
The dataset name of the disk configuration file exceeded the
44-character limit. Shorten the device address domain ID.
The specified storage system is already defined in the route.
Select a different storage system.
"Storage System Sense Byte
List of Messages 77