HP XP P9500 Manual page 145

Table 42 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKZ29x) (continued)
Message ID
Y0KZ297E MSG SC=44
RC=44
Message Text
An error occurred while adding
JNLG to EXCTG. (JNLG=jj,
MIRROR=m, EXCTG=e,
SN=ssssssssssss, CDEV=cccc,
CODE=nnnn)
Explanation and Recommended Actions
message will appear until the registration has
completed normally.
Also, if you execute the YKQUERY command to obtain
the status while the copy pair of the copy group
containers with EXCTG ID specified is dissolved, the
YKZ296E message sometimes appears when the
dissolving of the copy pair is detected at a different
time from the dissolving of EXCTG, but this does not
mean that an error has occurred. In this case, wait
until the copy pair status changes to SIMPLEX, and
then re-execute the YKQUERY command. The message
will no longer appear.
JNLG (string)
The journal type not being
registered (the journal type of the
definition, rather than of the
storage system)
R-JNL: Journal of the secondary
site
M-JNL: Journal of the primary site
jj (hexadecimal number)
The journal group number (00-FF)
specified by the C/T group ID or
sub C/T group ID
m (decimal number)
Mirror ID (0-3)
e (decimal number)
EXCTG ID (0-3)
ssssssssssss (decimal number)
Storage system serial number
An error occurred while registering the journal group
to EXCTG.
Register the error code and determine the cause of
the problem. After removing the cause of the
problem, execute the YKMAKE command again with
a SELECT(COND) specification to register the journal
group to EXCTG.
This message is output until the corresponding EXCTG
registration process is executed using the YKMAKE
command again.
JNLG (string)
The journal type not being
registered (the journal type of the
definition, rather than of the
storage system)
R-JNL: Journal of the secondary
site
M-JNL: Journal of the primary site
jj (hexadecimal number)
List of Messages 145