HP XP P9500 Manual page 54

Table 8 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKG2x) (continued)
Message ID
YKJ212E TSO
RC=32
YKJ213E TSO
RC=32
YKJ214W TSO
RC=8
YKJ215E TSO
RC=32
54 Messages
Message Text
A specific combination of a
storage system serial number
and a C/T group ID is used
for multiple CAJ Copy
Groups: dd-name: rec#
Secondary volume is already
specified in another copy
pair as a secondary device:
dd-name: rec#
A copy pair capacity check
could not be performed
because the capacity of a
volume could not be
acquired.
The capacities of the copy
pair volumes are different:
dd-name: rec#
Explanation and Recommended Actions
The combination of the copy groups is one of the following:
The serial numbers of the primary site storage systems are the same;
the serial numbers of the secondary site storage systems are
different; and copy pairs with an equal C/T group ID exist.
The serial numbers of the primary site storage systems are different;
the serial numbers of the secondary site storage systems are the
same; and copy pairs with an equal sub C/T group ID exist.
If the copy type is Cnt Ac-J Z, these combinations are not supported.
dd-name
DD name of the CSV file where the error was
detected
rec#
Number of the line in the file identified by
dd-name where the error was detected
The volume specified as the S-VOL is also specified as the S-VOL
for other copy pairs. The same volume cannot be specified as the
S-VOL for multiple copy pairs.
dd-name
DD name of the CSV file where the error was
detected
rec#
Number of the line in the file identified by
dd-name where the error was detected
A copy pair capacity check could not be performed because the
capacity of a volume could not be acquired. A capacity check
cannot be performed in either of the following cases:
When a volume capacity has not been acquired during a Local
Scan, Remote Scan, or NG Scan.
When a volume is in any of the storage systems below and a
Remote Scan or NG Scan has been performed on the volume.
In this case, the capacity of the volume cannot be acquired.
◦
XP1024/XP128 Disk Array
◦
XP12000 Disk Array
◦
XP24000 Disk Array
A copy group definition file was created, but the settings might
contain incorrect information.
The capacities of the copy pair volumes are different. A copy pair
whose P-VOL and S-VOL capacities are different cannot be defined.
To create a copy pair whose P-VOL and S-VOL capacities are
different for migration, specify NOCHECK for the CAPACITY
parameter, and execute the YKIMPORT command. For details, see
the HP P9000 for Business Continuity Manager Software Reference
Guide.
dd-name
The dd name of the CSV file where the error was
dectected.
rec#