HP XP P9500 Manual page 28

Table 1 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YK80x) (continued)
Message ID
YK9080E CON
YK9081W CON
Table 2 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKA0x)
Message ID
YKA000T TSO
YKA001E TSO
YKA002E TSO
YKA003E TSO
YKA004E TSO
YKA006E TSO
28 Messages
Message Text
The expiration date for your
license key (function).
Your function license will
expire in n days.
Message Text
Supplied parameters invalid
HANDLE() value not valid
HANDLE() parameter
required for this operation
OP(OPEN|GET|CLOSE)
option required
Buffer full; messages
discarded
SYSTEM ERROR. error-type
Explanation and Recommended Actions
The license (function) has expired.
To continue using this product after the expiry date, you need a
permanent license.
If function is Basic:
A permanent license for Business Continuity Manager Basic is
required.
If function is Cnt Ac-S Z Sync Extended CTG:
A permanent license for Business Continuity Manager Extended CT
Group is required.
If function is Cnt Ac J 4x4 Extended CTG:
A permanent license for Business Continuity Manager Hitachi
Universal Replicator™ for Mainframe (Cnt Ac-J Z) 4x4 Extended
CTG is required.
The license (function) will expire in n days.
To continue using this product after the expiry date, you need a
permanent license.
If function is Basic:
A permanent license for Business Continuity Manager Basic is
required.
If function is Cnt Ac-S Z Sync Extended CTG:
A permanent license for Business Continuity Manager Extended CT
Group is required.
If function is Cnt Ac J 4x4 Extended CTG:
A permanent license for Business Continuity Manager Cnt Ac-J Z
4x4 Extended CTG is required.
Explanation and Recommended Actions
An error was detected during parameter analysis.
The handle value assigned to the HANDLE parameter is invalid.
The OP(GET) and OP(CLOSE) requests require the HANDLE
parameter to be specified.
Use the handle value returned by the OP(OPEN) request in the
YKA098I message.
The OP parameter is missing.
Specify the OP parameter.
An attempt to acquire the IEA494I console message, IOSHM0414I
console message, or the message specified in the MSGID parameter
of the YKCONMSG command failed. This problem might occur when
console message traffic is too high or when the YKCONMSG
command issuance interval is too long.
When you receive this message, issue the YKQUERY command to
check the copy pair status.
A system error was detected.
Contact technical support for assistance.
error-type