HP XP P9500 Manual page 220

Table 63 Details of Error Codes CBxx
Error Error Details
Code
A copy pair cannot be made
CB10
because there was an attempt to
make a copy pair for both
directions with the same C/T group
ID.
A copy pair cannot be added to a
CB18
C/T group where the P-VOL and
the S-VOL are being swapped.
A dummy volume cannot be
CB1D
created on the S-VOL.
The current RCU version does not
CB1F
support Fibre Cnt Ac-S Z or TCA.
Fibre Cnt Ac-S Z or TCA has not
CB60
been installed on the RCU.
Copy pairs with Fibre and ESCON
CB61
paths cannot exist within the same
C/T group.
Copy pairs with Fibre and ESCON
CB62
paths cannot exist within the same
storage system.
The storage system type of the
CB64
MCU is not supported (not
3990-6/6E, or is 2105).
The upper limit of 4,096 (or more)
CB69
copy pairs cannot be made within
the same C/T group by RCU.
A copy pair cannot be made
CB78
because the specified S-VOL is
defined as a command device.
A Cnt Ac-S Z or TCA copy pair
CB7E
cannot be made because the CLPR
that the specified S-VOL belongs to
differs from the one registered in
the C/T group. For details on the
CLPR, see the storage system
documentation.
A copy pair cannot be made
CB9E
because the specified S-VOL does
not support either one or both of
the following:
The timestamp transfer mode
The Open/MF Consistency
Preservation Function
A copy pair cannot be made
CBD8
because the specified P-VOL is not
a P-VOL for Cnt Ac-J Z.
A copy pair cannot be created
CBD9
because the specified S-VOL
220 Storage System Sense Byte Information
Type of Error
BC Z Cnt Ac-S Z TCA
Not output Output
Not output Output
Not Output
output
Not Output
output
Not Output
output
Not output Output
Not Output
output
Not Output
output
Not output Output
Not Output
output
Not Output
output
Not Output
output
Not Output
output
Not Output
output
Cnt Ac-J Z CMD PATH
Not output
Not output
Not output
Not output
Not output
Not output
Not output
Not output
Not output
Not output
Not output
Not output
Not output
Not output
Others