HP XP P9500 Manual page 18

Table 1 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YK80x) (continued)
Message ID
YK8221I PRT CON
YK8222E PRT CON
YK8223W PRT
CON
YK8230E PRT CON
YK8231E PRT CON
YK8300I PRT CON
18 Messages
Message Text
time YKEWAIT (RC=4) :
TIMEOUT value (timeout)
reached.
time YKEWAIT (RC=8) :
Unexpected status reached.
time cmd (RC=4) : Some
volumes with invalid status
found.
time REPORT type is only
valid for TCA or CAJ Copy
Groups.
time BCM Monitor can not
adjust Copy Group status.
time sendmsg
Explanation and Recommended Actions
The number of lines equal to the number of
messages included in the message structure are
displayed.
The YKEWAIT command timed out before the transition to the
expected group status.
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
timeout
Timeout value
An unexpected group status was reached during execution of the
YKEWAIT command.
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
Invalid volumes were detected in the copy group during the
execution of the CLI command cmd. Processing of these volumes
was skipped.
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
type, which was specified for the REPORT parameter, is only valid
for TCA or Cnt Ac-J Z copy groups.
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
type
Report type
BCM Monitor could not set the copy group to the specified startup
status.
time
Message output time
This is only displayed when the output
destination is SYSTSPRT.
The message identified by sendmsg appears. The message is
specified in SENDMSG with the STATUS level designated.
time
Message output time