HP XP P9500 Manual page 33

Table 3 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKC0x) (continued)
Message ID Message Text
YKC002E MSG Results STEM(stem) does not
SC=48 RC=48 include trailing "."
YKC008E MSG Ending TO() not valid hex
SC=48 RC=48
YKC008E MSG Starting FROMVSN() value
SC=48 invalid
YKC008E MSG Ending TOVSN() value invalid
SC=48
YKC008E MSG Starting FROM() not valid hex
SC=48 RC=48
YKC009E MSG Specify DEV# and VOLSER
SC=48 RC=48 parm exclusively
YKC009E MSG Starting FROM() exceeds
SC=48 RC=48 ending TO()
YKC009E MSG Starting FROMVSN() exceeds
SC=48 RC=48 ending TOVSN()
YKC010E TSO REXX failure return
RC=40 code=nnnn starting with
variable name
YKC031I MSG Scanned DASD Device Count
SC=0 (count)
YKC032I MSG HP RAID Storage Systems
SC=0 (count) Found
YKC033I MSG The specified devices that do
SC=4 (count) not have any available I/O
paths were skipped.
YKC034E MSG A dynamic configuration
SC=32 RC=32 change was detected during
YKSCAN command
processing.
Explanation and Recommended Actions
stem
Stem name assigned to the MSG parameter
The last character of the STEM parameter is not a period.
stem
Stem name assigned to the STEM parameter
The value specified in the TO parameter is not in hexadecimal
format.
The value specified in the FROMVSN parameter is invalid.
The value specified in the TOVSN parameter is invalid.
The value specified in the FROM parameter is not in hexadecimal
format.
You cannot specify a device number and a volume serial number
at the same time.
The value specified in the FROM parameter exceeds the value of
the TO parameter.
The value specified in the FROMVSN parameter exceeds the value
of the TOVSN parameter.
Access to the REXX variable identified by name failed.
For details about the return code, see IKJCT441 in the TSO/E
Programming Services.
nnnn
Error code returned upon REXX access
The number of DASD devices scanned by the YKSCAN command.
count
Number of scanned DASD devices
The number of HP RAID storage systems scanned by the YKSCAN
command.
count
Number of HP RAID storage systems
As a result of the device scan, information acquisition on devices
for which no I/O path is available was skipped.
count
The number of devices skipped when the device
information was acquired
A dynamic change to an I/O configuration definition was detected
during processing of the YKSCAN command. This error might have
been caused by the volume serial number in the acquired volume
information being different from the one in the actual configuration.
List of Messages 33