HP XP P9500 Manual page 102

Table 30 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKY0x) (continued)
Message ID
YKY021I CON
YKY022I CON
YKY051I CON
YKY052I CON
YKY053I CON
Table 31 Business Continuity Manager Error Messages and Corresponding Troubleshooting Actions
(Message ID YKY1x)
Message ID
YKY100I CON
YKY101I CON
YKY102I CON
YKY103I CON
YKY104I CON
YKY1 1 1I CON
YKY1 14I CON
102 Messages
Message Text
A NAME/TOKEN WRITE ERROR
OCCURRED,
RC=return-code,
NAME=name
THE SPECIFIED PREFIX IS BEING
USED BY ANOTHER PROGRAM
AGENT ENDED
AGENT IN SCHEDULED
SHUTDOWN
AGENT ABENDED
Message Text
MODIFY COMMAND
ACCEPTED
STOP COMMAND ACCEPTED
INVALID error-type: text
COMMAND SYNTAX ERROR
OPERAND IS INCORRECT
parameter-name WAS
CHANGED
parameter-name=
parameter-value
Explanation and Recommended Actions
The command cannot be executed because a
NAME/TOKEN write error occurred. The Business
Continuity Manager agent will now stop.
return-code
Return code set by the
NAME/TOKEN registration
routine(IEANTCR)
name
Name registered in the
NAME/TOKEN service
The specified prefix is being used by another program.
Check the initialization parameters.
The Business Continuity Manager agent was
terminated.
The Business Continuity Manager agent termination
processing has begun.
The Business Continuity Manager agent terminated
abnormally.
If the cause is unknown, collect the ABEND dump in
the SYSABEND dump format and then contact customer
support for investigation.
Explanation and Recommended Actions
The MODIFY command was accepted.
The STOP command was accepted.
After an entry of the MODIFY command, an error was
detected in the command or operand shown as text.
Check, and, if necessary, revise the command.
error-type
COMMAND: Indicates that an error was detected in
the command.
OPERAND: Indicates that an error was detected in
the operand.
The entered command has a syntax error.
Check, and, if necessary, revise the command.
The specified operand is invalid.
Correct the error and then re-enter the operand.
The value of the initialization parameter has been
changed. The parameter name is given in
parameter-name.
This message displays the current value of the
initialization parameter.