HP XP P9500 Manual page 200

Table 57 Details of Error Codes 8Dxx (continued)
Error Error Details
Code
The command cannot be executed
8D42
because the volume specified as a
command device is a volume used
in the open system.
The command could not be
8D43
executed because the logical
volume of the specified volume is
blocked.
The command could not be
8D44
executed because the specified
volume has PIN data.
The command device cannot be
8D45
defined. The reason might be one
of the following:
The corresponding volume is
executing a remote control
command as a command
device.
The corresponding volume is
part of a Cnt Ac-S Z or TCA
copy pair.
The command device cannot be
8D46
deleted. The reason might be one
of the following:
The corresponding volume is
executing a remote control
command as a command
device.
The corresponding volume is
part of a Cnt Ac-S Z or TCA
copy pair.
The command could not be
8D47
executed because the specified
volume is a BC Z volume.
The command could not be
8D4D
executed because the specified
volume does not exist.
A command device cannot be
8D4E
defined because it differs from the
APID that was already registered.
The command could not be
8D4F
executed because the specified
volume is online.
The host command parameter is
8D50
incorrect.
The command could not be
8D51
executed because the logical
volume of the specified volume is
blocked or the specified volume is
in the NOT READY status.
200 Storage System Sense Byte Information
Type of Error
BC Z Cnt Ac-S Z
Not output
Not output
Not output
Not output
Not output
Not output
Not output
Not output
Not output
Not output
Not output
TCA Cnt Ac-J Z CMD
Output
Output
Output
Output
Output
Output
Output
Output
Output
Not output
Output
PATH Others
Not output
Not output
Not output
Not output
Not output
Not output
Not output
Not output
Not output
Output
Not output