Setting Up The Post-Migration Environment - Hitachi XP P9500 User Manual

¢
¢
5 Get Solaris to recognize the LUs to be used by the post-migration boot
.
disk.
6 Set the LU slices to be used by the post-migration boot disk.
.
7 Allocate the LUs to be used in the post-migration environment by
.
applications that require storage system LUs other than the boot disk.
8 Get Solaris to recognize the disk used by applications if not already
.
recognized.
9 Set the disk slice to be used by applications if not already set.
.
10 Complete the preparations for installing HDLM in the pre-migration
.
environment and then install HDLM, referring to the description in
Installing HDLM on page
Perform the necessary steps.
After you finish these steps, perform the procedure described in
the Post-Migration Environment on page

Setting Up the Post-Migration Environment

If you use the dlmsetboot utility, go to step 12, because the utility
automatically executes steps 1 through 11. For details on the dlmsetboot
utility, see
Disk Environment on page
1 Set the boot block for the post-migration environment, specifying the
.
post-migration slice 0 (/ (root) file system).
The following shows an example of executing the command:
# installboot /usr/platform/`uname -i`/lib/fs/ufs/bootblk /dev/
rdsk/c8t50060E80004361D1d1s0
2 Initialize the Solaris file system in the post-migration environment. If
.
using Sun Cluster, also initialize the Sun Cluster global device file system.
The following shows an example of executing the command:
# newfs /dev/rdsk/c8t50060E80004361D1d1s0
# newfs /dev/rdsk/c8t50060E80004361D1d1s6
# newfs /dev/rdsk/c8t50060E80004361D1d1s3
3 Mount the Solaris file system in the post-migration environment. If using
.
Sun Cluster, also mount the Sun Cluster global device file system.
The following shows an example of executing the command:
To the slices of a single LU, allocate the Solaris file system, swap
devices, dump devices, Sun Cluster global device file system, and
replica of the SDS or SVM state database.
To the slices of multiple LUs, allocate the Solaris file system, swap
devices, dump devices, Sun Cluster global device file system, and
replica of the SDS or SVM state database.
In this case, make sure that the physical path of each LU is the same.
The dlmsetboot Utility for Assisting Configuration of an HDLM Boot
7-21.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
3-41.
3-85.
Setting Up
3-85