Hitachi XP P9500 User Manual page 294

specifies that the LU indicated by that LDEV attribute is not to be
managed by HDLM.
Figure 4-8 The /opt/DynamicLinkManager/config/dlmfdrv.unconf file
(before editing) on page 4-48
DynamicLinkManager/config/dlmfdrv.unconf file (after editing) on page
4-48
file (/opt/DynamicLinkManager/config/dlmfdrv.unconf).
The shaded portion indicates the text to be edited.
Note
5 Apply the settings in the HDLM driver unconfiguration definition file (/
.
opt/DynamicLinkManager/config/dlmfdrv.unconf) to the HDLM driver
configuration definition file (/kernel/drv/dlmfdrv.conf).
Execute the following command:
# /opt/DynamicLinkManager/bin/dlmsetconf -u
6 If you are using VxVM, you need to release, from the VxVM disabled
.
state, the device that you want to remove from HDLM management.
Delete the target device from the /etc/vx/vxvm.exclude file.
Figure 4-10 Result output by executing the dlmvxexclude utility on page
4-49
assisting creation of the VxVM configuration file and
the /etc/vx/vxvm.exclude file on page 4-49
etc/vx/vxvm.exclude file.
4-48
show examples of editing the HDLM driver unconfiguration definition
Figure 4-8 The /opt/DynamicLinkManager/config/dlmfdrv.unconf
Figure 4-9 The /opt/DynamicLinkManager/config/dlmfdrv.unconf
Do not edit anything other than deleting the hash mark (#) from the
beginning of the LDEV property line.
shows the results output by executing the dlmvxexclude utility for
HDLM Operation
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
and Figure 4-9 The /opt/
file (before editing)
file (after editing)
shows the coding in the /
Figure 4-11 Coding in