To Display The Format Of The Online Operation; Parameters; To Place Paths Online - Hitachi XP P9500 User Manual

[-hba host-port-number.bus-number
|-hbaid HBA-port-ID
|-cha -pathid AutoPATH_ID
|-chaid CHA-port-ID
|-pathid AutoPATH_ID
|-device SCSI-device-name]
[-s]

To display the format of the online operation

/opt/DynamicLinkManager/bin/dlnkmgr online -help

Parameters

To place paths online

-path
Indicates that the target of the operation is a path managed by HDLM.
This parameter is optional because online is always used for paths, so it
is assumed.
Make sure that you specify the path to be taken online by using the -hba,
-hbaid, -cha, -chaid, -pathid, or -device parameter. If you do not
specify any of these parameters, the command will place all the offline
paths online. If there is a path that cannot be placed online, a message
asking whether you would like to continue processing will be displayed. To
ignore the offline path that cannot be placed online and to continue
processing, enter y. To stop the processing, enter n.
-hba host-port-number.bus-number
Use this parameter to place online, at one time, all the paths that pass
through a specific HBA port. The command will place online all the paths
connected to the HBA port that has the specified host port number and
bus number.
Specify the host port number and bus number of the target HBA port: the
numbers are found in the PathName field displayed using the view
operation. Enter a period between these two parameter values. For
details on the view operation, see
6-30.
Example
6-12
The following example shows how to place online all paths connected
to the HBA port whose host port number is 0001 and bus number is
0000:
When the confirmation message is displayed, the user enters y to
continue, or n to cancel the operation.
# /opt/DynamicLinkManager/bin/dlnkmgr online -hba 0001.0000
KAPL01057-I All the paths which pass the specified HBA will
Command Reference
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
view (Displays Information) on page