Hitachi XP P9500 User Manual page 232

8 Confirm that the cluster node enters the maintenance mode.
.
Make sure that the node that is in the maintenance mode has the
following status:
¢
¢
The following shows an example of executing the command:
host2# /usr/cluster/bin/scstat -q
9 If the cluster is a two-node configuration, enter the install mode.
.
If the cluster consists of three or more nodes, this step is not necessary
so go to step 10. The following shows an example of executing the
command:
host2# /usr/cluster/bin/scconf -c -q installmode
10 Release the settings of the last Quorum device.
.
The following shows an example of executing the command:
host2# /usr/cluster/bin/scconf -r -q globaldev=Quorum-device's-
device-ID
11 At a node that is not in the maintenance mode, switch to become the
.
superuser.
If the cluster consists of two nodes, go to step 13. If the cluster consists
of three or more nodes, go to step 12.
12 If the cluster consists of three or more nodes, reset the cluster Quorum
.
votes.
The following shows an example of executing the command:
host2# /usr/cluster/bin/scconf -c -q node=host1,reset
13 Change the mode of the node, which you changed into the maintenance
.
mode, back to the previous mode.
At the ok prompt, execute boot.
14 If the cluster consists of two nodes, make sure that the node (which was
.
changed into the maintenance mode) that you want to change back to the
previous mode is active, and then reset the cluster Quorum votes. If the
cluster consists of three or more nodes, this step is not necessary.
The following shows an example of executing the command:
host2# /usr/cluster/bin/scconf -c -q node=host1,reset
3-168
The node is in the Offline status.
Both the current Quorum votes present and Quorum votes
possible are 0.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))