Hitachi XP P9500 User Manual page 151

/dev/dsk/c8t50060E80004361D1d1s0 /dev/rdsk/
c8t50060E80004361D1d1s0 / ufs 1 no -
/dev/dsk/c8t50060E80004361D1d1s6 /dev/rdsk/
c8t50060E80004361D1d1s6 /usr ufs 1 no -
/dev/did/dsk/d30s3 /dev/did/rdsk/d30s3 /global/.devices/
node@1 ufs 2 no global
#
Execute the scdidadm -l command to find out the device ID to
specify as the mount device of the Sun Cluster global device file
system. In the following example, d24 is the pre-migration boot disk,
and d30 is the post-migration boot disk.
# scdidadm -l
...
24 node1:/dev/rdsk/c0t0d0 /dev/did/rdsk/d24
...
30 node1:/dev/rdsk/c8t50060E80004361D1d1 /dev/did/rdsk/d30
9 Edit the post-migration boot disk's /etc/vfstab file, changing the swap
.
device definition from the pre-migration boot disk to the post-migration
boot disk.
An example is shown below.
Before editing
/dev/dsk/c0t0d0s1 - - swap - no -
After editing
/dev/dsk/c8t50060E80004361D1d1s1 - - swap - no -
10 Edit the post-migration boot disk's /etc/dumpadm.conf file, changing the
.
dump device definition in the DUMPADM_DEVICE parameter from the pre-
migration boot disk to the post-migration boot disk.
An example is shown below.
Before editing
DUMPADM_DEVICE=/dev/dsk/c0t0d0s1
After editing
DUMPADM_DEVICE=/dev/dsk/c8t50060E80004361D1d1s1
11 To enable the system to boot from the post-migration environment, find
.
the boot device name to specify in the OpenBoot PROM (OBP).
The paths that can be specified as the boot device in the OBP depend on
the Solaris version, as follows:
In Solaris 8 or Solaris 9:
¢
As the boot device, you can specify any owner path of the boot disk.
In Solaris 10:
¢
As the boot device, you can only specify a boot disk path used by
HDLM to determine the logical device file name of the HDLM device.
To find this path, perform the procedure described in
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
When the Path
3-87