Hitachi XP P9500 User Manual page 129

When the Bourne or Korn shells is used, add the path as shown below:
PATH=$PATH:/opt/DynamicLinkManager/bin ; export PATH
When the C shell is used, add the path as shown below:
set path=( $path /opt/DynamicLinkManager/bin )
33 Execute the following command to view the HDevName and iLU columns:
.
# /opt/DynamicLinkManager/bin/dlnkmgr view -path
Check the execution results of this command to determine the
correspondence between each HDevName (logical device file name of the
HDLM device) and iLU (the internal LU number). Then, compare the
correspondence of the logical device file names and internal LUs that took
place before HDLM was installed, and then re-register the correct HDLM
devices in those programs that will use these devices.
To use an HDLM-managed device with a file system created by using
volume management software, perform step 34.
To use an HDLM-managed device with a file system created without using
volume management software, perform steps 35 to 37.
34 Register the disk device group.
.
If you are using VxVM, see
If you are using SDS, see
Registering HDLM Devices on page
If you are using SVM, see
Registering HDLM Devices on page
35 In Sun Cluster, to create a new shared file system, create it in any HDLM-
.
managed device from a desired node.
The following shows an example of executing the command:
host1# newfs /dev/global/rdsk/d5s0
36 Execute the following command to create a directory for mounting on
.
each node:
The following shows an example of executing the command:
host1# mkdir -p /global/mntpt
host2# mkdir -p /global/mntpt
37 On the desired node, mount the file system. The following shows an
.
example of executing the command:
host1# mount -g /dev/global/dsk/d5s0 /global/mntpt
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
Linking VxVM and Sun Cluster on page
To Use a Shared Diskset on page 3-158
3-157.
To Use a Shared Diskset on page 3-161
3-161.
3-154.
in
in
3-65