Hitachi XP P9500 User Manual page 296

Note
9 Execute the dlnkmgr command's view operation on all nodes in the
.
cluster, and display the status of each program.
The following shows an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys
HDLM Version
Service Pack Version
Load Balance
Support Cluster
Elog Level
Elog File Size (KB)
Number Of Elog Files
Trace Level
Trace File Size(KB)
Number Of Trace Files
Path Health Checking
Auto Failback
Intermittent Error Monitor
HDLM Manager Ver
Alive
HDLM Alert Driver Ver
Alive
HDLM Driver
Alive
License Type Expiration
Permanent
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
#
¢
10 Use the execution results from the view operation to check that the
.
programs are operating normally.
If HDLM Manager, HDLM Alert Driver, and HDLM Driver are all Alive,
the programs are operating normally.
11 Check the LU that you removed from HDLM management.
.
You can check the LU by using the format command.
Example of executing the format command on page 4-51
4-50
The following message might be output to the console window or
syslog while the node is running:
Unable to open '/dev/rdsk/c5t50060E80033A9902d2s2'
This message is output when an HDLM-managed device has been
changed to a non-HDLM-managed device. Perform the procedure for
updating the device ID information (steps 12 to 15) so that this
message is not output next time the node starts. For details, refer to
the Sun Cluster documentation.
x.x.x-xx
x.x.x-xx
Ver
x.x.x-xx
-
Even when cluster software is used, it is not displayed in Support
Cluster. Nevertheless, no problem exists with the functionality for
cluster support.
HDLM Operation
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
: x.x.x-xx
:
: on(extended lio)
:
: 3
: 9900
: 2
: 0
: 1000
: 4
: on(30)
: on(1)
: off
WakeupTime
yyyy/mm/dd hh:mm:ss
WakeupTime
yyyy/mm/dd hh:mm:ss 4096
WakeupTime
yyyy/mm/dd hh:mm:ss
ElogMem Size
Figure 4-12
shows an