Storage System; Command Execution; Using A Sun Hba; Starting The Host, System, And Hdlm In A Solaris 10 Environment - Hitachi XP P9500 User Manual
Hitachi dynamic link manager software user guide for solaris (6.6) (hit5205-96011, november 2011)
Hide thumbs
Also See for XP P9500:
- User manual (746 pages) ,
- User manual (188 pages) ,
- User manual (640 pages)
Table of Contents
Advertisement
The shaded portion indicates mapping from combinations of sd or ssd device
types and instance numbers to HDLM device logical device file names.
Storage System
•
Start up the storage system before you start up the hosts, so that Solaris
can detect the storage system.
•
Do not change the vendor ID or product ID of a storage system. If you
change either of them, HDLM will not be able to recognize the storage
system.
Command Execution
When a path error occurs while a file system is being created or formatted or
the fsck command is being executed, the operation might not have been
completed. If so, recover from the path error, and then perform the operation
again.
Using a Sun HBA
If all of the following conditions are satisfied, the KAPL08019-E and
KAPL08022-E messages indicating a path error may be output to /var/adm/
messages during boot processing (even when the path is normal):
•
Solaris 8 or Solaris 9 is used.
•
A Sun HBA that the ssd driver recognizes is used.
If this situation occurs, execute the dlnkmgr view -path command to check
the path status after the completion of booting. There are no problems if the
path is in Online status.
Starting the Host, System, and HDLM in a Solaris 10 Environment
When starting the host
HDLM Operation
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
4-3
Advertisement
Table of Contents
