Hitachi XP P9500 User Manual page 410

dlmfdrv.unconf) contains an invalid entry or does not exist, an error
occurs. This parameter cannot be specified together with the -r
parameter.
Examples
Example 1
Parameters are omitted:
A configuration definition file is created in the /kernel/drv directory. If
the configuration definition file already exists, the existing definition
information is inherited, and the parts for the changed configuration are
added and/or deleted.
# /opt/DynamicLinkManager/bin/dlmsetconf
Example 2
The -d parameter is specified:
A configuration definition file is created in the /tmp directory:
# mkdir /tmp/dlmdir
# /opt/DynamicLinkManager/bin/dlmsetconf -d /tmp/dlmdir
Example 3
The -r parameter is specified:
A new configuration definition file is created in the /kernel/drv directory.
Existing information is not inherited.
# /opt/DynamicLinkManager/bin/dlmsetconf -r
Example 4
The -u parameter is specified:
Defines a non- HDLM-managed LU based on the contents of the
definitions in the HDLM driver unconfiguration definition file (/opt/
DynamicLinkManager/config/dlmfdrv.unconf):
# /opt/DynamicLinkManager/bin/dlmsetconf -u
Note
• Execution of the dlmsetconf utility causes sd or ssd devices to be
defined in the HDLM driver configuration definition file (/kernel/drv/
dlmfdrv.conf) in units of LUs.
• Executing the dlmsetconf utility outputs the KAPL10242-I message.
Entering y in response to this message creates or updates the HDLM
driver configuration definition file (/kernel/drv/dlmfdrv.conf), the
7-24
Utility Reference
Hitachi Dynamic Link Manager User Guide (for Solaris(R))