Hitachi XP P9500 User Manual page 420

Key name
auto_failback_int
erval
intermittent_erro
r_monitor
intermittent_erro
r_monitor_interva
#4
l
intermittent_erro
r_monitor_number
4
Legend:
Optional: If you omit the key name and value, the following value is
used:
¢
¢
Note
Audit log settings are not supported.
#1
Only one key name and value can be specified on each line.
7-34
#1
Explanation
Specify the path status check
interval, which is the interval
between the end of the
previous check and the start
of the next check, in minutes.
You can specify a value from
1 to 1440. The default is 1.
Specify whether to enable
#3#4 intermittent error monitoring
by specifying either of the
following values:
on: Enable intermittent error
monitoring.
off: Disable intermittent
error monitoring (default).
Specify the interval for
intermittent error monitoring
in minutes.
You can specify a value from
1 to 1440. The default is 30.
Specify how many times an
# error must occur to cause
HDLM to assume an
intermittent error.
You can specify a value from
1 to 99. The default is 3.
For a new installation
The default is used.
For an upgrade installation or re-installation
The previous setting value is inherited.
Utility Reference
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
Required or
optional?
Required
#2
for new
installatio
n
Optional
Optional
Optional
Optional
Required
Maximum
for
length
upgrade
(characte
installati
rs)
on or re-
installati
on
Optional 4
Optional 3
Optional 4
Optional 2