Setting Up Integrated Traces - Hitachi XP P9500 User Manual

After you have set up the collection of audit log data, use the following
command to make sure that the setting has been specified correctly:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -audlog
Audit Log
Audit Log Category
Audit Log Facility
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd
#

Setting up Integrated Traces

When HDLM is used, the dlnkmgr command logs are output to the integrated
trace information files of Hitachi Network Objectplaza Trace Library
(HNTRLib2) (/var/opt/hitachi/HNTRLib2/spool/hntr2n.log (n indicates a
file number)).
If a lot of integrated trace information is output, the older information might
end up getting deleted in a very short amount of time. Also, if a large amount
of integrated trace information is suddenly all output at the same time, any
integrated trace information that is overflowing the buffer might not be saved
into the integrated trace files. To save as much information as possible,
change the settings for Hitachi Network Objectplaza Trace Library to increase
the integrated trace file size and buffer size. Note that if the values are too
large, it will place a heavy load on the system. When determining these
values, be sure to consider these operational tradeoffs.
Table 3-30 Default and recommended values for the integrated trace file
settings on page 3-129
integrated trace file settings.
Table 3-30 Default and recommended values for the integrated trace file
Integrated trace file size
Number of integrated trace files
Buffer size per
monitoring
interval
Number of
messages to be
output per
monitoring
interval
If Hitachi Network Objectplaza Trace Library (HNTRLib2) is already installed,
the existing settings will be inherited. If you change these settings, keep in
shows the default and recommended values for the
Setting
Monitoring interval
Buffer size
Monitoring interval
Number of messages
to be output
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
: on(6)
: all
: local0
hh:mm:ss
settings
Default value
256 (kilobytes)
4
10 (seconds)
64 (kilobytes)
0 (seconds)
0 (transactions)
Recommended
value
4096 (kilobytes)
8
5 (seconds)
256 (kilobytes)
0 (seconds)
0 (transactions)
3-129