Hitachi XP P9500 User Manual page 273
Hitachi dynamic link manager software user guide for solaris (6.6) (hit5205-96011, november 2011)
Hide thumbs
Also See for XP P9500:
- User manual (746 pages) ,
- User manual (640 pages) ,
- User manual (188 pages)
Table of Contents
Advertisement
# /usr/cluster/lib/sc/scsi -c inkeys -d /dev/rdsk/
c3t50060E80033A9902d2s2
If the key is displayed, perform the steps beginning with step 5. Even
when you release the setup for Quorum devices and disk device groups,
since the key used for disk reservation will remain registered, you will
need to restart the node in non-cluster mode and unregister the key.
If the key is not displayed, perform the steps beginning with step 9.
5
Simultaneously stop all nodes in the cluster.
.
Execute the following command on any node:
# /usr/cluster/bin/scshutdown -g0 -y
6
Start all nodes in the cluster in non-cluster mode.
.
At the ok prompt, execute the boot -x command.
7
Unregister the key for the LU newly recognized by the node.
.
Execute the following command on any node:
# /usr/cluster/lib/sc/scsi -c scrub -d the-name-of-the-logical-
device-file-on-slice-2-of-the-LU-newly-recognized-by-the-node
The following shows an example of executing the command:
# /usr/cluster/lib/sc/scsi -c scrub -d /dev/rdsk/
c3t50060E80033A9902d2s2
8
Make sure that the key for the LU newly recognized by the node has been
.
unregistered.
Perform step 4 again on any node, and check that the key is not
displayed.
9
Make sure that the logical device files for the sd or ssd device are backed
.
up.
When you restart the node, with the reconfiguration option specified,
after running the dlmsetconf utility in the next step (step 10), the logical
device files of the sd or ssd device to be managed by HDLM will be
deleted. Make sure that these files are backed up before you execute the
dlmsetconf utility to restart the node. For details on how to back up files,
see step 4 in
Performing Operations on Devices to Be Managed by HDLM
on page 3-41
of
3-41.
10
Use the following dlmsetconf utility to create the HDLM driver
.
configuration definition file (/kernel/drv/dlmfdrv.conf) and the HDLM
driver unconfiguration definition file (/opt/DynamicLinkManager/config/
dlmfdrv.unconf).
# /opt/DynamicLinkManager/bin/dlmsetconf
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
Preparations for a New Installation of HDLM on page
HDLM Operation
4-27
Advertisement
Table of Contents
