Migration By Building A New Pre-Migration Environment - Hitachi XP P9500 User Manual

2 Get Solaris to recognize the LUs to be used by the post-migration boot
.
disk.
3 Set the LU slices to be used by the post-migration boot disk.
.
4 Complete the preparations for installing HDLM in the pre-migration
.
environment and then install HDLM, referring to the description in
Installing HDLM on page
Perform the necessary steps.
Note
After you finish these steps, perform the procedure described in
the Post-Migration Environment on page

Migration by Building a New Pre-Migration Environment

Perform the following steps in the pre-migration environment. The workflow
is shown in
building a new pre-migration environment on page
Note the following when you set the devices to be excluded at step 11
of Performing a New Installation of HDLM (When Sun Cluster Is Not
Being Used) on page 3-49
Installation of HDLM (When Sun Cluster Is Being Used) on page
- If the boot disk in the pre-migration environment is an HDLM-
managed device, change the setting to exclude it from HDLM
management.
- Set the post-migration boot disk as an HDLM-managed device.
Figure 3-11 Flow of setting up the boot disk environment when
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
3-41.
or in step 17 of
3-85.
Performing a New
Setting Up
3-84.
3-56:
3-83