Hitachi XP P9500 User Manual page 134

If 2 is entered, a message that prompts you to enter a license key is
displayed. Enter the license key.
¢
¢
6 Execute the following command to check that the package is installed, by
.
the version number in the output results:
The following shows an example of executing the command:
# pkginfo -l DLManager
CATEGORY:
#
7 Restart the host.
.
When Sun Cluster is not being used:
Execute one of the following commands:
¢
¢
When Sun Cluster is being used:
Execute the following command at one of the nodes:
# /usr/cluster/bin/scshutdown -g0 -y
Then, execute the following command at the ok prompt in all nodes:
boot
Note
8 Execute the dlnkmgr command's view operation to display the status of
.
the programs.
The following shows an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys
HDLM Version
Service Pack Version
Load Balance
Support Cluster
Elog Level
Elog File Size (KB)
Number Of Elog Files
Trace Level
Trace File Size(KB)
Number Of Trace Files
3-70
When a correct license key is entered, the installation program
displays a message that indicates the license was installed.
Take care that if you enter an incorrect license key three times,
installation stops.
PKGINST: DLManager
NAME: Dynamic Link Manager
system
ARCH: sparc
VERSION: xx.x.x.xxxx
BASEDIR: /
VENDOR:
...
# reboot
boot (at the ok prompt)
You must restart the host immediately after a successful upgrade
installation or re-installation has been confirmed.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
: x.x.x-xx
:
: on(rr)
:
: 3
: 9900
: 2
: 0
: 1000
: 4