Format; Parameters - Hitachi XP P9500 User Manual

The dlmcfgmgr utility is valid in Solaris 8 version 1/01 or later, Solaris 9, or
Solaris 10 system.

Format

/opt/DynamicLinkManager/bin/dlmcfgmgr { -a | -h }

Parameters

-a
Applies the contents of the HDLM driver configuration definition file (/
kernel/drv/dlmfdrv.conf) to HDLM driver. The added LU becomes valid
after the command with this option is executed. The HDLM devices for the
deleted LUs become unavailable after the command with this option is
executed.
-h
Displays help about the usage of the command.
Examples
Example 1: The -a option is specified:
Information on the newly added LUs is applied to the HDLM driver based
on the contents of the HDLM driver configuration definition file (/kernel/
drv/dlmfdrv.conf). In Solaris 10, information on the LUs that were
disconnected from the host is deleted from the HDLM driver. In Solaris 8
or 9, information on LUs that are already managed by HDLM is not
updated.
# /opt/DynamicLinkManager/bin/dlmcfgmgr -a
Example 2: Options are omitted:
In this example, the dlmcfgmgr utility outputs an error message and
displays help about the usage of the command.
# /opt/DynamicLinkManager/bin/dlmcfgmgr
KAPL10380-E A parameter is invalid.
KAPL10368-I usage: dlmcfgmgr {-a | -h}
#
Note
¢
¢
7-16
Execute the dlmsetconf utility for creating the HDLM driver
configuration definition file before executing the dlmcfgmgr utility.
If you use VxVM, do not use the dlmcfgmgr utility. Instead, specify
the reconfiguration option, and then restart the host. To register the
HDLM device to VxVM or cancel the HDLM device registration from
VxVM, you need to restart with the reconfiguration option specified.
Utility Reference
Hitachi Dynamic Link Manager User Guide (for Solaris(R))