Checking The Updated Settings - Hitachi XP P9500 User Manual

define the output destination of the facility in the /etc/syslog.conf file.
Table 3-29 Values Indicating Audit Log Facility on page 3-128
values that indicate audit log facility. The default is user.
user or 1
local0 or 16
local1 or 17
local2 or 18
local3 or 19
local4 or 20
local5 or 21
local6 or 22
local7 or 23
This example shows how to specify the audit log facility:
# /opt/DynamicLinkManager/bin/dlnkmgr set -audfac local0

Checking the Updated Settings

This chapter describes how to check the updated settings by using the
dlnkmgr command's set operation after settings have been changed.
When you change some settings, you can display information about all of
HDLM function settings. The following shows an example of the command
used to display the settings information and its execution results:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -sfunc
HDLM Version
Service Pack Version
Load Balance
Support Cluster
Elog Level
Elog File Size(KB)
Number Of Elog Files
Trace Level
Trace File Size(KB)
Number Of Trace Files
Path Health Checking
Auto Failback
Intermittent Error Monitor
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
#
3-128
Table 3-29 Values Indicating Audit Log Facility
Value Corresponding facility value in the /etc/syslog.conf file
user
local0
local1
local2
local3
local4
local5
local6
local7
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
: x.x.x-xx
:
: on(extended lio)
:
: 2
: 1000
: 5
: 1
: 2000
: 10
: on(10)
: on(10)
: on(2/20)
describes the