Hitachi XP P9500 User Manual page 307

9 Delete the device ID information for devices that do not exist.
.
Execute the following command:
# /usr/cluster/bin/scdidadm -C
10 Allocate the device ID.
.
Execute the following command:
# /usr/cluster/bin/scdidadm -r
11 Notify the node of the most recent device ID information.
.
Execute the following command:
# /usr/cluster/bin/scdidadm -ui
12 Update the Sun Cluster global device namespace.
.
Execute the following command:
# /usr/cluster/bin/scgdevs
13 When using an HDLM-managed device, as a Quorum device, set the
.
Quorum device on any node in the cluster.
The following shows examples of executing the commands:
Check the device ID of the HDLM device:
# /opt/DynamicLinkManager/bin/dlnkmgr view -path
# /usr/cluster/bin/scdidadm -L
Set up the Quorum device:
# /usr/cluster/bin/scconf -a -q globaldev=d4
Execute the following command to clear the install mode of a cluster
when it consists of two nodes:
# /usr/cluster/bin/scconf -c -q reset
14 Execute the following command to view the HDevName and iLU columns:
.
# /opt/DynamicLinkManager/bin/dlnkmgr view -path
Check the correspondence between HDevName (the name of the logical
device file of the HDLM device) and iLU (the internal LU number) from
the execution results of the command, compare the correspondence with
the correspondence that took place before the HDLM installation, and
then re-register HDLM devices with the programs that will use them.
If you want to use volume management software to create a file system
on an HDLM-managed device, skip to step 16.
15 Perform registration for the disk device group.
.
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
HDLM Operation
4-61