Adding An Ip Interface; Statically Configuring An Ip Interface; Enabling The Dhcp Client - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

You can add an IP interface to a VLAN by statically configuring an IP address or by enabling the
Dynamic Host Configuration Protocol (DHCP) client on the VLAN.
To add an IP interface to a VLAN, use the following command:
set interface vlan-id ip {ip-addr mask | ip-addr/mask-length}
The MSS DHCP client enables a switch to obtain its IP configuration from a DHCP server. A switch can
use the DHCP client to obtain the following configuration information:
• IP address
• Default router (gateway)
• DNS domain name
• DNS server IP address
The DHCP client is implemented according to "RFC 2131: Dynamic Host Configuration Protocol" and
"RFC 2132: DHCP Options and BOOTP Vendor Extensions". The client supports the following options:
• (12) Host Name
• (55) Parameter request list, consisting of (1) Subnet Mask, (3) Router, (15) Domain Name, and
(6) Domain Name Server
• (60) Vendor Class Identifier, set to DLINK x.x.x, where x.x.x is the MSS version
The DHCP client is disabled by default on the DWS-1008. You can enable the DHCP client on one VLAN
only.
MSS also has a configurable DHCP server. You can configure a DHCP client and DHCP server on the
same VLAN, but only the client or the server can be enabled. The DHCP client and DHCP server cannot
both be enabled on the same VLAN at the same time.
D-Link DWS-1008 User Manual

Adding an IP Interface

Statically Configuring an IP Interface

Enabling the DHCP Client