D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual page 191

3. Set the SSID in the service profile to thiscorp. Type the following command:
DWS-1008# set service-profile wpa-wep ssid-name thiscorp
success: change accepted.
4. Enable WPA in service profile wpa-wep. Type the following command:
DWS-1008# set service-profile wpa-wep wpa-ie enable
success: change accepted.
5. Enable the WEP40 cipher suite in service profile wpa-wep. Type the following command:
DWS-1008# set service-profile wpa-wep cipher-wep40 enable
success: change accepted.
TKIP is already enabled by default when WPA is enabled.
6. Display the service profile wpa-wep to verify the changes. Type the following command:
DWS-1008# show service-profile sp1
7. Map service profile wpa-wep to radio profile rp2. Type the following commands:
DWS-1008# set radio-profile rp2 service-profile wpa-wep
success: change accepted.
8. Apply radio profile rp2 to radio 1 on port 5 and to radios 1 and 2 on port 6, enable the
radios, and verify the configuration changes. Type the following commands:
DWS-1008# set ap 5,6 radio 1 radio-profile rp2 mode enable
success: change accepted.
DWS-1008# set ap 11 radio 2 radio-profile rp2 mode enable
success: change accepted.
DWS-1008# show ap config
Port 5: AP model: dwl-8220ap, POE: enable, bias: high, name: MP05
boot-download-enable: YES
force-image-download: YES
Radio 1: type: 802.11a, mode: enabled, channel: 36
tx pwr: 1, profile: rp2
auto-tune max-power: default
Port 6: AP model: dwl-8220ap, POE: enable, bias: high, name: MP06
boot-download-enable: YES
force-image-download: YES
Radio 1: type: 802.11g, mode: enabled, channel: 6
tx pwr: 1, profile: rp2
auto-tune max-power: default
Radio 2: type: 802.11a, mode: enabled, channel: 36
tx pwr: 1, profile: rp2
auto-tune max-power: default
9. Save the configuration. Type the following command:
DWS-1008# save config
success: configuration saved.
D-Link DWS-1008 User Manual 1