Logging To The Trace Buffer; Enabling Mark Messages; Saving Trace Messages In A File - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

Trace logging is enabled by default and stores debug-level output in the switch trace buffer. To modify
trace logging to an event level higher than debug, use the following command:
set log trace severity severity-level
To disable trace logging, use the following command:
set log trace disable
success: change accepted.
You can configure MSS to generate mark messages at regular intervals. The mark messages indicate
the current system time and date. D-Link can use the mark messages to determine the approximate
time when a system restart or other event causing a system outage occurred.
Mark messages are disabled by default. When they are enabled, MSS generates a message at the
notice level once every 300 seconds by default.
To enable mark messages, use the following command:
DWS-1008# set log mark enable
success: change accepted.
To save the accumulated trace data for enabled traces to a file in the switch's nonvolatile storage, use
the following command:
save trace filename
To save trace data into the file trace1 in the subdirectory traces, type the following command:
DWS-1008# save trace traces/trace1
D-Link DWS-1008 User Manual

Logging to the Trace Buffer

Enabling Mark Messages

Saving Trace Messages in a File