To change the IGMP query interval timer, use the following command:
set igmp qi seconds [vlan vlan-id]
For seconds, you can specify a value from 1 through 65,535. The default is 125 seconds.
Changing the Other-Querier-Present Interval
To change the other-querier-present interval, use the following command:
set igmp oqi seconds [vlan vlan-id]
For seconds, you can specify a value from 1 through 65,535. The default is 255 seconds.
Changing the Query Response Interval
To set the query response interval, use the following command:
set igmp qri tenth-seconds [vlan vlan-id]
You can specify a value from 1 through 65,535 tenths of a second. The default is 100 tenths of a second
(10 seconds).
Changing the Last Member Query Interval
To set the last member query interval, use the following command:
set igmp lmqi tenth-seconds [vlan vlan-id]
You can specify a value from 1 through 65,535 tenths of a second. The default is 10 tenths of a second
(1 second).
Robustness adjusts the IGMP timers to the amount of traffic loss that occurs on the network. Set the
robustness value higher to adjust for more traffic loss. To change the robustness value, use the following
command:
set igmp rv num [vlan vlan-id]
You can specify a value from 2 through 255. The default is 2.
D-Link DWS-1008 User Manual
Changing the Query Interval
Changing Robustness
18