Configuring For A Distributed Ap; Setting A Port For A Wired Authentication User - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

To configure a connection for a Distributed AP (referred to as a DAP in the CLI), use the following
command:
set dap dap-num serial-id serial-ID
model {dwl-8220ap} [radiotype {11b| 11g}]
The dap-num parameter identifies the Distributed AP connection for the AP. The range of valid connection
ID numbers depends on the switch model. The table below lists the ranges of valid dap-num values for
each model.
For the serial-id parameter, specify the serial ID of the AP. The serial ID is listed on the AP case. To
display the serial ID using the CLI, use the show version details command.
The model and radiotype parameters have the same options as they do with the set port type ap
command. Because the switch does not supply power to an indirectly connected AP, the set dap
command does not use the poe parameter.
To configure Distributed AP connection 1 for AP model DWL-8220AP with serial-ID 0322199999, type
the following command:
DWS-1008# set dap 1 serial-id 0322199999 model dwl-8220ap
success: change accepted.

Setting a Port for a Wired Authentication User

To set a port for a wired authentication user, use the following command:
set port type wired-auth port-list [tag tag-list] [max-sessions num]
[auth-fall-thru {last-resort | none | web-portal}]
You must specify a port list. Optionally, you also can specify a tag-list to subdivide the port into virtual
ports, set the maximum number of simultaneous user sessions that can be active on the port, and
change the fallthru authentication type.
By default, one user session can be active on the port at a time.
The fallthru authentication type is used if the user does not support 802.1X and is not authenticated by
MAC authentication. The default is none, which means the user is automatically denied access if neither
802.1X authentication or MAC authentication is successful.
To set port 2 as a wired authentication port, type the following command:
DWS-1008# set port type wired-auth 2
success: change accepted
This command configures port 2 as a wired authentication port supporting one interface and
one simultaneous user session.
D-Link DWS-1008 User Manual

Configuring for a Distributed AP

8