Displaying Rf Auto-Tuning Information; Displaying Rf Auto-Tuning Settings - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

Displaying RF Auto-Tuning Information

You can display the RF Auto-Tuning configuration, a list of RF neighbors, and the values of RF
attributes.

Displaying RF Auto-Tuning Settings

To display the RF Auto-Tuning settings that you can configure in a radio profile, use the following
command:
show radio-profile {name | ?}
Entering show radio-profile ? displays a list of radio profiles.
To display the RF Auto-Tuning and other settings in the default radio profile, type the following command.
(This example shows the RF Auto-Tuning parameters in bold type.)
DWS-1008# show radio-profile default
Beacon Interval: 100
Max Tx Lifetime: 2000
RTS Threshold: 2346
Long Preamble: no
Tune Power: no
Tune Power Interval: 600
Channel Holddown: 300
Active-Scan: yes
WMM Powersave: no
No service profiles configured.
To display the RF Auto-Tuning settings that you can configure on an individual radio, use the following
commands:
show ap config [port-list [radio {1 | 2}]]
show dap config [dap-num [radio {1 | 2}]]
To display the RF Auto-Tuning and other individual radio settings on radio 1 of a directly connected
access port connected to port 2, type the following command:
DWS-1008# show ap config 2 radio 1
Port 2: AP model: DWL-8220AP, POE: enable, bias: high, name: AP02
boot-download-enable: YES
force-image-download: NO
Radio 1: type: 802.11g, mode: disabled, channel: 6
tx pwr: 1, profile: default
auto-tune max-power: default
D-Link DWS-1008 User Manual
DTIM Interval: 1
Max Rx Lifetime: 2000
Frag Threshold: 2346
Tune Channel: yes
Tune Channel Interval: 3600
Power ramp interval: 60
Countermeasures: none
RFID enabled: no
QoS Mode: wmm
18