Resetting The Stp Port Cost To The Default Value; Changing The Stp Port Priority - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

Resetting the STP Port Cost to the Default Value

To reset the STP port cost to the default value, use one of the following commands:
clear spantree portcost port-list
clear spantree portvlancost port-list {all | vlan vlan-id}
The command applies only to the ports you specify. The port cost on other ports remains unchanged.
To reset the cost of ports 3 and 4 in the default VLAN to the default value, type the following
command:
DWS-1008# clear spantree portcost 3-4
success: change accepted.
To reset the cost of ports 3 and 4 for VLAN beige, type the following command:
DWS-1008# clear spantree portvlancost 3-4 vlan beige
success: change accepted.
To change the priority of a port, use one of the following commands:
set spantree portpri port-list priority value
set spantree portvlanpri port-list priority value {all | vlan vlan-id}
The set spantree portpri command changes the priority for ports in the default VLAN (VLAN 1) only.
The set spantree portvlanpri command changes the priority for ports in a specific other VLAN or in
all VLANs.
Specify a priority from 0 (highest priority) through 255 (lowest priority). The default is 128.
The all option applies the change to all VLANs. Alternatively, specify an individual VLAN.
To set the priority of ports 3 and 4 in the default VLAN to 48, type the following command:
DWS-1008# set spantree portpri 3-4 priority 48
success: change accepted.
To set the priority of ports 3 and 4 to 48 in VLAN mauve, type the following command:
DWS-1008# set spantree portvlanpri 3-4 priority 48 vlan mauve
success: change accepted.
D-Link DWS-1008 User Manual

Changing the STP Port Priority

0