Resetting The Update Interval To The Default; Enabling The Ntp Client; Displaying Ntp Information - D-Link DWS-1008 - AirPremier MobileLAN Switch Product Manual

Resetting the Update Interval to the Default

To reset the update interval to the default value, use the following command:
clear ntp update-interval
The NTP client is disabled by default. To enable the NTP client, use the following command:
set ntp {enable | disable}
To display NTP information, use the following command:
show ntp
Here is an example:
DWS-1008> show ntp
NTP client: enabled
Current update-interval: 20(secs)
Current time: Sun Feb 29 2004, 23:58:12
Timezone is set to 'PST', offset from UTC is -8:0 hours. Summertime is enabled.
Last NTP update: Sun Feb 29 2004, 23:58:00
NTP Server Peer state
--------------------------------------------------
192.168.1.5 SYSPEER
The Timezone and Summertime fields are displayed only if you change the timezone or enable
summertime.
D-Link DWS-1008 User Manual

Enabling the NTP Client

Displaying NTP Information

Local State
SYNCED
8